"Ground effect" refers to the enhanced performance enjoyed by fliers or
swimmers operating close to the ground. We derive a number of exact solutions
for this phenomenon, thereby elucidating the underlying physical mechanisms
involved in ground effect. Unlike previous analytic studies, our solutions are
not restricted to particular parameter regimes such as "weak" or "extreme"
ground effect, and do not even require thin aerofoil theory. Moreover, the
solutions are valid for a hitherto intractable range of flow phenomena
including point vortices, uniform and straining flows, unsteady motions of the
wing, and the Kutta condition. We model the ground effect as the potential flow
past a wing inclined above a flat wall. The solution of the model requires two
steps: firstly, a coordinate transformation between the physical domain and a
concentric annulus, and secondly, the solution of the potential flow problem
inside the annulus. We show that both steps can be solved by introducing a new
special function which is straightforward to...

more |
pdf
| html
None.

StarshipBuilder:
Exact solutions for ground effect
https://t.co/UVMKUkAkEX

None.

None.

Sample Sizes : None.

Authors: 4

Total Words: 0

Unqiue Words: 0

When boiling occurs in a liquid flow field, the phenomenon is known as
forced-convection boiling. We numerically investigate such a boiling system on
a cylinder at a saturated condition. To deal with the complicated liquid-vapor
phase-change phenomenon, we develop a numerical scheme based on the
pseudopotential lattice Boltzmann method (LBM). The collision stage is
performed in the space of central moments (CMs) to enhance numerical stability
for high Reynolds numbers. The adopted forcing scheme, consistent with the
CMs-based LBM, leads to a concise yet robust algorithm. Furthermore, additional
terms required to tune thermodynamic consistency are derived in a CMs
framework. The effectiveness of the present scheme is successfully tested
against a series of boiling processes, including nucleation, growth, and
departure of a vapor bubble for Reynolds numbers varying between $30$ and
$30000$. Unlike the Navier--Stokes-based simulations, our CMs-based LBM can
reproduce all the boiling regimes, {\it i.e.}, nucleate boiling,...

more |
pdf
| html
None.

None.

None.

Sample Sizes : None.

Authors: 8

Total Words: 0

Unqiue Words: 0

This paper employs an input-output based approach to analyze convective
velocities and the transport of fluctuations in turbulent channel flows. The
convective velocity for a fluctuating quantity associated with
streamwise-spanwise wavelength pairs at each wall-normal location is obtained
through the maximization of the power spectral density associated with the
linearized Navier-Stokes equations with a turbulent mean profile and
delta-correlated Gaussian forcing. We first demonstrate that the mean
convective velocities computed in this manner agree well with those reported
previously in the literature. We then exploit the analytical framework to probe
the underlying mechanisms contributing to the local convective velocity at
different wall-normal locations by isolating the contributions of each
spanwise-streamwise wavelength pair (flow scale). The resulting analysis
suggests that the behavior of the convective velocity in the near-wall region
is influenced by large scale structures further away from the wall. These
structures...

more |
pdf
| html
None.

None.

Sample Sizes : None.

Authors: 2

Total Words: 14939

Unqiue Words: 3004

General Defocusing Particle Tracking (GDPT) refers to a class of
three-dimensional particle tracking methods that use a single-camera view and
determine the particle depth positions from the defocusing patterns of the
corresponding particle images. Its distinctive feature is to access particles'
depth coordinates through a direct comparison of the particle images with a set
of reference particle images at known depth positions. Many implementations of
GDPT are possible, especially with respect to how to compare target and
calibration images, how to deal with overlapping particle images, and how to
optimize the computational time. The emergence of new and more sophisticated
GDPT approaches requires the definition of the method fundamentals as well as a
standardized framework for the objective assessment of the method performance
and applicability. To meet this need, we identify and describe the fundamental
concepts and parameters defining GDPT. We define guidelines for a standardized
assessment of the efficiency and uncertainty of...

more |
pdf
| html
None.

None.

Sample Sizes : None.

Authors: 2

Total Words: 9451

Unqiue Words: 2260

Vortex is a central concept in the understanding of turbulent dynamics.
Objective algorithms for the detection and extraction of vortex structures can
facilitate the physical understanding of turbulence regeneration dynamics by
enabling automated and quantitative analyses of these structures. Despite the
wide availability of vortex identification criteria, they only label spatial
regions belonging to vortices, without any information on the identity,
topology and shape of individual vortices. This latter information is stored in
the axis lines lining the contours of vortex tubes. In this study, a new
tracking algorithm is proposed which propagates along the vortex axis lines and
iteratively searches for new directions for growth. The method is validated in
flow fields from transient simulations where vortices of different shapes are
controllably generated. It is then applied to statistical turbulence for the
analysis of vortex configurations and distributions. It is shown to reliably
extract axis lines for complex...

more |
pdf
| html
None.

None.

Sample Sizes : None.

Authors: 2

Total Words: 19754

Unqiue Words: 4396

The role of thermodynamics in deriving constitutive equations is unique, and
various approaches have been developed in the last decades. In the present
paper, the frameworks of Extended Irreversible Thermodynamics (EIT) and
Non-Equilibrium Thermodynamics with Internal Variables (NET-IV) are discussed
and compared to each other on the basis of a particular problem of rarefied
gases. In this comparison, both theoretical and experimental aspects are taken
into account. Eventually, an experiment by Meyer and Sessler covering a wide
range of pressures and frequencies is investigated. Here, concentrating on the
scaling properties and the density dependence of parameters, the change of
speed of sound in terms of frequency and pressure is recovered using NET-IV,
and this fitting is compared to the results of Lebon and Cloot using EIT.

more |
pdf
| html
None.

CondensedPapers:
When theories and experiments meet: rarefied gases as a benchmark of non-equilibrium thermodynamic models. https://t.co/tzff5QvRwt

None.

None.

Sample Sizes : None.

Authors: 3

Total Words: 0

Unqiue Words: 0

The linear spatiotemporal stability properties of axisymmetric laminar
capillary jets with fully developed initial velocity profiles are studied for
large values of both the Reynolds number, $Re=Q/(\pi\,a\,\nu)$, and the Froude
number, $Fr=Q^2/(\pi^2\,g\,a^5)$, where $a$ is the injector radius, $Q$ the
volume flow rate, $\nu$ its kinematic viscosity, and $g$ the gravitational
acceleration. The downstream development of the basic flow and its stability
are addressed with an approximate formulation that takes advantage of the jet
slenderness. The base flow is seen to depend on two parameters, namely a Stokes
number, $G=Re/Fr$, and a Weber number, $We=\rho\,Q^2/(\pi^2\,\sigma\,a^3)$,
where $\sigma$ is the surface tension coefficient, while its linear stability
depends also on the Reynolds number. When non-parallel terms are retained in
the local stability problem, the analysis predicts a critical value of the
Weber number, $We_c(G,Re)$, below which a pocket of local absolute instability
exists within the near field of the jet. The...

more |
pdf
| html
None.

None.

None.

Sample Sizes : None.

Authors: 1

Total Words: 0

Unqiue Words: 0

The increasing use of microfluidics in industrial, biomedical, and clinical
applications requires a more and more precise control of the microfluidic flows
and suspended particles or cells. This leads to higher demands in
three-dimensional and automated particle tracking methods, e.g. for use in
feedback-control systems. In order to meet these demands, we present in this
work an algorithm for performing General Defocusing Particle Tracking (GDPT) in
a fast, versatile, and automated manner. GDPT is a 3D particle tracking method
based on defocused particle images which is suitable for non-expert users and
requires only standard laboratory equipment. The presented algorithm includes
(i) an automatic identification of particles via the a priori measured
reference set of particle images, (ii) a quick depth coordinate determination
through a prediction of expected particle image similarities, and (iii) an
iterative approach for detection of overlapping particles. We show that the
algorithm is versatile and can be applied to different...

more |
pdf
| html
None.

None.

None.

Sample Sizes : None.

Authors: 2

Total Words: 0

Unqiue Words: 0

This article presents an original methodology for the prediction of steady
turbulent aerodynamic fields. Due to the important computational cost of
high-fidelity aerodynamic simulations, a surrogate model is employed to cope
with the significant variations of several inflow conditions. Specifically, the
Local Decomposition Method presented in this paper has been derived to capture
nonlinear behaviors resulting from the presence of continuous and discontinuous
signals. A combination of unsupervised and supervised learning algorithms is
coupled with a physical criterion. It decomposes automatically the input
parameter space, from a limited number of high-fidelity simulations, into
subspaces. These latter correspond to different flow regimes. A measure of
entropy identifies the subspace with the expected strongest non-linear behavior
allowing to perform an active resampling on this low-dimensional structure.
Local reduced-order models are built on each subspace using Proper Orthogonal
Decomposition coupled with a multivariate...

more |
pdf
| html
None.

None.

Sample Sizes : None.

Authors: 3

Total Words: 11814

Unqiue Words: 3090

In this study, the new concept of vortex core line based on Liutex definition
is applied to demonstrate that vortex ring is not part of the Lambda-vortex and
the generation of ring like vortex is formed separately from the Lambda-vortex.
The proper orthogonal decomposition is also applied to analyze the Kelvin
Helmholtz instability happening in hairpin ring areas of flow transition on the
flat plate to understand the ring like vortex formation. The new identification
method named modified Omega-Liutex method is efficiently used to visualize and
observe the shapes of vortex structures in 3D. The streamwise vortex structure
characteristics can be found in POD Mode1 as the mean flow. The other POD modes
are in spanwise structures and have the fluctuation motions, which are induced
by KH instability. Moreover, the result shows that fluctuated POD modes are in
pairs and share the same characteristics such as amplitudes, mode shapes and
time evolutions. The vortex core and POD results confirm that the Lambda-vortex
is not self deformed...

more |
pdf
| html
None.

None.

None.

Sample Sizes : None.

Authors: 2

Total Words: 0

Unqiue Words: 0

Assert is a website where the best academic papers on arXiv (computer science, math, physics), bioRxiv (biology), BITSS (reproducibility), EarthArXiv (earth science), engrXiv (engineering), LawArXiv (law), PsyArXiv (psychology), SocArXiv (social science), and SportRxiv (sport research) bubble to the top each day.

Papers are scored (in real-time) based on how verifiable they are (as determined by their Github repos) and how interesting they are (based on Twitter).

To see top papers, follow us on twitter @assertpub_ (arXiv), @assert_pub (bioRxiv), and @assertpub_dev (everything else).

To see beautiful figures extracted from papers, follow us on Instagram.

*Tracking 234,442 papers.*

Sort results based on if they are interesting or reproducible.

Interesting

Reproducible